|
Callout |
Component Name |
|---|---|
|
1 |
Air Cleaner Outlet Duct Clamp. Procedure
Loosen clamp and remove air cleaner outlet duct from air cleaner assembly. |
|
2 |
Mass Flow Sensor Procedure
Disconnect mass air flow sensor wiring harness plug from mass air flow sensor and unclip from retainer clip. |
|
3 |
Air Cleaner Assembly |
General
Air Cleaner Element ReplacementEmblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Brake Drum Replacement (J93, J94)
Special Tools
CH-41013 Rotor Resurfacing Kit
CH-42450-A Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: Refer to Brake Dust Warning.
Release the park brake.
Raise and support the vehicle. Refer to Lif ...
Intake Manifold Installation (1.6L LDE)
Clean the sealing surfaces.
Insert the NEW gasket.
Caution: Refer to Fastener Caution.
Install the intake manifold (2) and the 7 intake manifold bolts (1) and
tighten to 20 Y (15 lb ft).
Install the intake manifold supp ...