Chevrolet Sonic Repair Manual: Body Panel Paint Protector Replacement (VGC)
- The paint protective film and vehicle surface temperature should be 13?€“32?°C (55?€“90?°F) for best results.
- Automatic car washes should be avoided for at least 24?€‰hours after the paint protective film application.
- Wipe the vehicle surface with isopropyl alcohol or flash naptha at the application area.
- Dry the surface with a clean lint-free cloth.
- Create a mixture of 25 percent isopropyl alcohol and 75 percent water and two drops of baby shampoo per 16?€‰oz of fluid mixture.
- Remove the backing liner from the protective film patch.
- Use the solution to liberally spray the adhesive side of the protective patch, the mounting location along with your hands.
- Position the paint protective film patch to the desired location on the vehicle.
- Spray the surface of the film with the alcohol, water and soap solution.
- Using a dampened squeegee, start at the center of the protective patch, working outward in order to remove the air and solution from under the protective patch.
- Release any air bubbles with a pin.
- Dry the surface with a clean, lint-free cotton cloth.
Basecoat/Clearcoat Paint Systems
Warning: Exposure to isocyanates during paint preparation and application
processes can cause severe breathing problems. Read and follow all of the instructions
from the manufacturers of pain ...
Brake Fluid Effects on Paint and Electrical Components Caution
Caution: Avoid spilling brake fluid onto painted surfaces, electrical
connections, wiring, or cables. Brake fluid will damage painted surfaces and
cause corrosion to electrical components. If ...
Other materials:
Rear Side Door Window Rear Guide Replacement
Rear Side Door Window Rear Guide Replacement
Callout
Component Name
Preliminary Procedure
Remove the rear side door trim panel. Refer to Rear Side Door Trim Replacement.
1
Rear Side Door Window R ...
Control Solenoid Valve and Transmission Control Module Assembly Replacement
Removal Procedure
Remove the transmission control valve body cover.
Refer to Control Valve Body Cover Replacement.
Disconnect the output speed sensor electrical connector (2).
Disconnect the shift position switch electrical connector (3).
Disconn ...
Low and Reverse and 1-2-3-4 Clutch Housing Assemble (6T30)
Table 1:
1??? Clutch Piston Installation
Table 2:
Low and Reverse Clutch Piston Installation
1??? Clutch Piston Installation
1??? Clutch Piston Installation
Callout
Component Name
...
0.0049