Chevrolet Sonic Repair Manual: Crankshaft Position System Variation Learn

Chevrolet Sonic Repair Manual / Powertrain / Engine / Engine Block / Cylinder Block / Crankshaft Position System Variation Learn

Note:

The crankshaft position sensor system variation learn procedure is required when the following service procedures have been performed, regardless of whether DTC P0315 is set:

Engine replacement
Engine control module (ECM) replacement
Crankshaft damper replacement
Crankshaft replacement
Crankshaft Position Sensor Replacement
Any engine repairs which disturb the crankshaft to crankshaft position sensor relationship

Note:

The ECM monitors certain component signals to determine if all the conditions are met to continue with the Crankshaft Position Variation Learn procedure.

Ignition ON, observe the DTC information with a scan tool. Verify no other DTCs are set, except DTCs P0300–P0304, or P0315.

If DTCs are set, except DTCs P0300–P0304, or P0315, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.

Select the Crankshaft Position Variation Learn Procedure with a scan tool and follow the on screen instructions:

Verify DTC P0315 does not set.

If DTC P0315 set, or another DTC is present refer to Diagnostic Trouble Code (DTC) List - Vehicle for the applicable DTC that set.

If the DTC does not set

All OK.

Crankshaft Balancer Replacement

Special Tools EN-470–B Angular Torque Wrench EN-49979 Crankshaft Shock Mount Retainer For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and suppo ...

Crankshaft and Bearing Cleaning and Inspection

Special Tools EN-45059 Torque Angle Sensor Kit GE-571-B Dial Gauge For equivalent regional tools, refer to Special Tools. Crankshaft End Play, Check Note: Cranksha ...

Other materials:

Engine Coolant Thermostat Housing Removal
Caution: Refer to Engine Coolant Thermostat Housing Caution. Remove the engine coolant thermostat housing retainer nut (4). Remove the engine coolant thermostat housing retainer (1). Remove the 4 engine coolant thermostat housing bolts (3). Remo ...

SAND mode
WARNING When SAND mode is activated in the Nissan Armada, the Vehicle Dynamic Control (VDC) system operates with reduced intervention. As a result, the system may not react in the same way as it does in STANDARD mode. To minimize the risk of accidents, always drive the Nissan Armada with caut ...

System maintenance
Example Basic information The two radar sensors A for the I-BSI system are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as snow, splashing water, mist or fog. The blocked condition ma ...

0.0062