Chevrolet Sonic Repair Manual: Fuel Tank Heat Shield Replacement
- Removal Procedure
-
- Support the fuel tank with a suitable jack.
- Remove the fuel tank strap fasteners (1) and lower the fuel tank straps (2).
- Remove the fuel tank heat shield fasteners (1) and remove the fuel tank heat shield (2).
- Installation Procedure
-
- Install the fuel tank heat shield (2) and tighten the fasteners (1)
to 10 Y (89 lb in)
.
- Install the fuel tank straps (2) and tighten the fasteners (1) to
22 Y (16 lb ft)
.
Caution:
Refer to Fastener Caution.
- Install the fuel tank heat shield (2) and tighten the fasteners (1)
to 10 Y (89 lb in)
Exhaust Rear Muffler Heat Shield Replacement
Exhaust Rear Muffler Heat Shield Replacement
Callout
Component Name
Preliminary Procedure
Disconnect the exhaust system hangers ...
Exhaust Manifold Cleaning and Inspection
Clean the exhaust manifold (1) in solvent.
Warning: Wear safety glasses in order to avoid eye damage.
Dry the exhaust manifold (1) with compressed air.
An exhaus ...
Other materials:
Washer Fluid
Open the cap with the washer symbol on it. Add washer fluid until the tank is
full. See Engine Compartment Overview for reservoir location.
Caution
. Do not use engine coolant (antifreeze) in the windshield washer. It
can damage the windshield washer system and paint.
. Do not mi ...
Secondary Air Injection System Description
The Secondary Air Injection System aids in the reduction of hydrocarbon exhaust
emissions during a cold start. This occurs when the start-up engine coolant temperature
(ECT) is between −10 to +56?C (14?33?F), the intake air temperature (IAT) is greater
than −10?C (14?F) and it has ...
Input, Reaction, and Output Carrier Disassemble
Input, Reaction, and Output Carrier Disassemble
Callout
Component Name
1
Output Carrier Assembly
Note:
The 6T30 and 6T40 have 4 pinions.
The 6T45 and 6T50 have 5 pinions.
...
0.0058