Chevrolet Sonic Repair Manual: Exhaust2
- Exhaust System Replacement
- Catalytic Converter Heat Shield Replacement (LUV)
- Exhaust Heat Shield Replacement
- Exhaust Manifold Heat Shield Installation
- Exhaust Manifold Heat Shield Removal
- Exhaust Manifold Heat Shield Replacement (LUV)
- Exhaust Manifold Heat Shield Replacement (LUW)
- Exhaust Rear Muffler Heat Shield Replacement
- Fuel Tank Heat Shield Replacement
- Exhaust Manifold Cleaning and Inspection
- Exhaust Manifold Heat Shield Installation
- Exhaust Manifold Heat Shield Removal
- Exhaust Manifold Heat Shield Replacement (LUV)
- Exhaust Manifold Heat Shield Replacement (LUW)
- Exhaust Manifold Installation
- Exhaust Manifold Removal
- Exhaust Manifold with Catalytic Converter Replacement (LUW)
- Clutch Actuator Cylinder Front Pipe Replacement
- Exhaust Front Pipe Replacement (LUV,LUW)
- Exhaust Rear Muffler Heat Shield Replacement
- Exhaust Rear Muffler Replacement (LUV,LUW)
Crankshaft Rear Oil Seal Replacement
Special Tools
EN-658 Rear Main Seal Installer
For equivalent regional tools, refer to Special Tools.
Removal Procedure
If equipped with automatic transmission, remove the flex plate ...
Exhaust System Replacement
Removal Procedure
Special Tools
CH-6614 Chain Pipe Cutter
For equivalent regional tools, refer to Special Tools.
Warning: Refer to Protective Goggles and Glove Warning
...
Other materials:
Airbag Instrument Panel Module Replacement
Airbag Instrument Panel Module Replacement
Callout
Component Name
Warning: Refer to SIR Inflator Module Handling and Storage
Warning.
Warning: Refer to SIR Warning.
Preliminary Procedure
Disable t ...
Shock Absorber Disposal
Warning: Use the proper eye protection when drilling to prevent metal
chips from causing physical injury.
Clamp the strut in a vise horizontally with the rod (1) completely extended.
Drill a hole in the strut at the center of the end cap (3) using a 5 mm
...
Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should
be performed before replacing the bushing, shaft, and in some cases, the component
which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces
before inspecting for damage.
Any of the followin ...
0.0053