Basic information
In the Nissan Armada, the electronic parking brake can also be controlled manually using the dedicated switch, allowing precise control in various driving and parking situations.
To apply: When the Nissan Armada is completely stopped and the ignition switch is in the ON or ACC position, pull the parking brake switch upward.
The indicator light on the switch and the electronic parking brake warning light
(PARK or
(red)) will illuminate, confirming that the parking brake is fully engaged.
To release: With the ignition switch in the ON position, press the brake pedal firmly and push the parking brake switch downward. The indicator light and the electronic parking brake warning light (red) will turn off, indicating that the parking brake has been released.
Before driving your Nissan Armada, always verify that the electronic parking brake warning light is OFF to ensure safe vehicle operation.
NOTE:
When towing a trailer
When towing with your Nissan Armada, especially on inclines, the combined weight of the vehicle and trailer may cause the vehicle to roll backward when starting from a stop.
In such situations, the Nissan Armada parking brake can be used similarly to a traditional handbrake to help control movement and prevent rollback.
Before moving off on a slope while towing, carefully follow these recommendations to maintain control:
Proper use of the Nissan Armada manual parking brake function enhances safety, particularly when maneuvering on slopes or handling additional loads such as trailers.
Automatic operationRadio without Touchscreen
To set the time and date:
1. Press CLOCK.
2. Select Time and Date Settings.
3. Select Set Time or Set Date.
4. Turn the MENU/TUNE knob to adjust the highlighted value.
5. Press the MENU/TUNE knob to select the next value.
6. To save the time or date and return to the Time and Date Settings men ...
Brake Pressure Modulator Valve Pipe Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution.
Caution: Always connect or disconnect the wiring harness connector
from the EBCM/EBTCM with the ignition switch ...
Starter Installation
Install the starter (4).
Install the lower starter bolt stud (3) and if equipped the washer.
Install the upper starter bolt (2) and if equipped the washer (1).
Caution: Refer to Fastener Caution.
Tighten the starter bolt and starter bolt stud to 25 ...