Chevrolet Sonic Repair Manual: Oil Level Indicator and Tube Installation
- Install a NEW oil level indicator tube gasket.
- Install the oil level indicator tube (2).
- Install the oil level indicator tube bolt (1) and tighten to 15 Y (11 lb ft)
.
- Install the oil dipstick.
Caution:
Refer to Fastener Caution.
Oil Level Indicator Tube Replacement
Removal Procedure
Note: If the engine oil level is at maximum, some oil may
emerge when drawing out the oil dipstick guide tube.
Place collecting basin underneath.
...
Oil Level Indicator and Tube Removal
Remove the oil dipstick.
Remove the oil level indicator tube bolt (1).
Note: If the engine oil level is at the maximum level, oil may
emerge while removing the oil dipstick ...
Other materials:
Front Fog Lamp Bulb Replacement
Front Fog Lamp Bulb Replacement
Callout
Component Name
Preliminary Procedure
Remove either the left front or right front wheelhouse liner. Refer
to Front Wheelhouse Liner Replacement.
Disconnect the electrical connector t ...
Rear Suspension Description and Operation
This vehicle has a beam rear suspension system consisting of the following components:
An axle with integral trailing arms
A cross beam
Two coil springs
Two standard shock absorbers
Axle Assembly
The axle assembly attaches to the underbody through a rubber bushing and
brac ...
Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the
cylinder head.
Disconnect the ignition coil electrical connector (2).
...
0.0055