Chevrolet Sonic Repair Manual: Shifter Input and Linkage

Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection

Removal Procedure Note: Perform the following procedure when removing the retaining rings and cooler lines from the quick connect fittings located on the radiator a ...

Automatic Transmission Range Selector Lever Replacement

Removal Procedure Set the park brake and chock the wheels. Disconnect the transmission range selector lever cable terminal (1) from the transmission manual shift leve ...

Other materials:

Front Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools DT-35910 Drive Axle Boot Clamp Pliers For equivalent regional tools, refer to Special Tools Disassemble Procedure Remove the wheel drive shaft from the vehicle. Refer to Front Wheel Drive Shaft Replacement. Install the drive axle shaft (1) i ...

Secondary Air Injection System Description
The Secondary Air Injection System aids in the reduction of hydrocarbon exhaust emissions during a cold start. This occurs when the start-up engine coolant temperature (ECT) is between −10 to +56°C (14?E33°F), the intake air temperature (IAT) is greater than −10°C (14°F) and it ...

Automatic Transmission Flex Plate Removal
Special Tools EN-652 Automatic Transmission Flex Plate Holder For equivalent regional tools, refer to Special Tools. Install the EN-652 holder  (1) to hold the automatic transmission flex plate (2). Loosen the 6 automatic transmission flex plate bolts. Re ...