Chevrolet Sonic Repair Manual: Restraints Control
- Airbag Front Passenger Presence Sensor Replacement
- Airbag Instrument Panel Module Replacement
- Airbag Roof Side Rail Module Replacement - Rear
- Airbag Sensing and Diagnostic Module Replacement
- Airbag Steering Wheel Module Coil Centering
- Airbag Steering Wheel Module Replacement
- Driver or Passenger Seat Shoulder Belt Replacement (with A69)
- Driver or Passenger Seat Shoulder Belt Replacement (without A69)
- Front End Inflatable Restraint Discriminating Sensor Replacement
- Front Seat Belt Anchor Plate Tensioner Replacement
- Front Seat Outboard Seat Back Airbag Replacement
- Inflatable Restraint Module Handling and Scrapping
- Instrument Panel Airbag Arming Status Display Replacement
- Instrument Panel Lower Airbag Replacement - Driver Side
- Instrument Panel Lower Airbag Replacement - Passenger Side
- Pretensioner Handling and Scrapping
- Rear Seat Outboard Seat Back Airbag Replacement
- Repairs and Inspections Required After a Collision
- Replacing Airbag System Parts after a Crash
- Replacing LATCH System Parts After a Crash
- Replacing Safety Belt System Parts after a Crash
- SIR Disabling and Enabling
- SIR Identification Views
- SIR Service Precautions
- Seat Adjustment
- Special Tools
- Steering Wheel Airbag Coil Replacement
- Supplemental Inflatable Restraint System Description and Operation
- Airbag Side Impact Sensor Replacement (with AYF/AYO)
- Inflatable Restraint Remote Impact Sensor Replacement
- Multi-Axis Acceleration Sensor Module Programming and Setup
Shoulder Belt Replacement - Rear (Sedan)
Shoulder Belt Replacement - Rear
Callout
Component Name
Preliminary Procedure
Remove the rear window panel trim. Refer to Rear ...
Airbag Front Passenger Presence Sensor Replacement
Airbag Front Passenger Presence Sensor Replacement
Callout
Component Name
Warning: Replace the passenger presence system as a ...
Other materials:
Checking Coolant
The vehicle must be on a level surface when checking the coolant level.
It is normal to see coolant moving in the upper coolant hose return line when
the engine is running.
Check to see if coolant is visible in the coolant surge tank. If the coolant
inside the coolant surge tank is boiling, do ...
Engine Block Disassemble
Remove the cylinder head locating (1, 2).
Remove the oil pressure switch (1).
Remove the knock sensor bolt (2) and the knock sensor (1).
Clean the thread.
Remove the oil flow check valve (1).
Remove the oil pressure rel ...
Intake Manifold Installation (1.8L LUW and LWE)
Clean the sealing surfaces.
Install 4 NEW gaskets.
Caution: Refer to Fastener Caution.
Install the intake manifold (2) and the 7 intake manifold bolts (1) and
tighten to 20 Y (15 lb ft).
Install the intake m ...
0.0065