Rail Dust Damage Repair
Air Inlet Grille Panel ReplacementFog Lamps (RS)
To replace the front fog lamp bulb:
1. Locate the fog lamp located under the front fascia.
2. Remove the cap from the back of the fog lamp assembly.
3. Disconnect the electrical connector from the fog lamp bulb assembly.
4. Remove the bulb by turning it counterclockwise and pulling it straight ...
Vehicle Yaw Sensor Learn
The yaw sensor does not require calibration often. Calibration of the yaw rate
sensor might be required after certain service procedures are performed. Some of
these procedures are as follows:
Electronic brake control module (EBCM) replacement
Multi-axis acceleration sensor replacement
...
Engine Replacement (Manual Transmission)
Special Tools
J-45859 Wheel Drive Shaft Remover .
CH-807 Closure Plugs .
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the battery and battery tray. Refer to Battery Tray Replacement.
Relieve the fuel system pressure. Refer to Fu ...