Engine
Air Conditioning Compressor Bracket InstallationBackup Lamp Switch Replacement
Removal Procedure
Disconnect the electrical connector from the backup lamp switch?€‰(1).
Remove the backup lamp switch?€‰(1) from the transmission.
Remove and DISCARD the backup lamp switch washer from the backup lamp
switch.
Installation Proc ...
Intake Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one
turn at a time until there is no spring tension pushing on the camshaft.
Note: Mind the markings on the camshaft bearing caps to ensure
they will be installed in the same position.
Remove the ...
Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should
be performed before replacing the bushing, shaft, and in some cases, the component
which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces
before inspecting for damage.
Any of the followin ...